Installing the
Linksys Dual-Band A+G Wireless Software and Card

Click here for Printer Friendly Version

Installing the Linksys Dual-Band A+G Wireless Software

1. Insert the Setup CD-ROM into your CD-ROM drive. The Setup Wizard should run automatically and the Welcome screen should appear. A window similar to the following will appear:
   
   
   
   Note: If the Welcome screen doesn’t appear then click the Start button and then choose Run. In the field that appears, enter D:\setup.exe (this assumes that “D” is the letter of your CD-ROM drive).
    
2. Click the Install button. A window similar to the following will appear:
   
   
   
    
3. After reading the License Agreement, click Next to continue the installation. A window similar to the following will appear:
   
   
   
    
4. Click the 2.4GHz radio button, and then click Next. A window similar to the following will appear:
   
   
    
5. Click the Infrastructure Mode radio button, and then enter the appropriate SSID. The default SSID setting is linksys. Change the default SSID to USC’s SSID. Click Next when finished.
   Note: If you are unaware of your SSID, it can be obtained via VIP.
    
6. The Setup Wizard will ask you to review your settings before it starts to install the files. A window similar to the following will appear:
   
   
    
7. Click Next to continue.
    
8. After the software has been successfully installed, click Exit.

1. Turn off your notebook PC.
    
2. Locate an available CardBus slot on your notebook PC.
    
3. With the wireless card label facing up, slide it completely into the CardBus slot on your notebook PC.
    
4. Turn on your notebook PC.
    
5. Windows will begin copying the driver files to your computer.
    
6. After installing the wireless card, the Dual-Band A+G Wireless Card WLAN Monitor icon will appear in the system tray, which is located at the bottom right corner of your screen.